It is trying to level but fails on the first point. asks me to manually level the last point. When I do, then I cannot hit save. Snapmaker error levelling

Yes the red light goes on if I hold something metal under it

[image] Cassiel101: I am having this same issue, has there been any kind of resolution? Which firmware are you using? -S

Try to roll back to 1.9 to see if the issue persists i know that i had this happen to me once but i cant for the life of me remember what i did about it maybe i just rebooted the machine and tried again but surely you;ve done that.

You did do the last part where you lower it down and measure with the card? Just making sure because a few people on FB have missed this. -S

Yes I did the last part :slight_smile: I rolled back the firmware as MooseJuice suggested and the leveling worked straight up first attempt. Thanks for the help guys! Not sure if that means 1.10 is bugged? Should I leave it at 1.9 and wait for a 1.11?

Rolling back to 1.9 fixed it. Dunno if that means 1.10 has a bug or something? I might keep using 1.9 for the moment

1.9 is the most stable, there are some bugs in the later releases thats not to say there arent bugs in 1.9. i personally use the latest version, but so many people have issues on it just kinda depends on where the goblins live i guess.

Absolutely no reason to update if it’s working. (No reason to go back to 1.9 if you’re not having problems either) 1.9 took care of some calibration and print gouging issues and added support for the enclosure. Personally I’m using 1.10.0 and there are two major bugs that I put up with: 99% on 3d…

Hey Everyone, I am having the same issue as the OP. Auto level goes to the first point and it continues moving down smashing into the bed. I have tried several firmware versions with the same result. I can see the light on the sensor but it doesn’t seem to be working. I will be trying a manual cali…

Auto levelling issue Snapmaker 2.0

Software Snapmaker Luban

stefix February 5, 2021, 9:00pm 34

Look at:

or:

Enough stuff to read

Topic		Replies	Views
Auto Leveling is not working Snapmaker 2.0 (3-in-1)	10	907	February 26, 2024
Calibration pushing deep into buildplate Snapmaker 2.0 (3-in-1)	106	10555	December 28, 2021
AutoCalibration Not Working Snapmaker 2.0 (3-in-1)	38	3885	October 30, 2020
Leveling / First layer Problems Snapmaker2.0 Troubleshooting guides	39	3285	July 19, 2021
Auto leveling failing on the 5 point. Manual calibration makes the unit throw mat on the floor Snapmaker 2.0 (3-in-1)	5	582	October 4, 2022

Auto levelling issue Snapmaker 2.0

Related topics