Snapmaker 2.0 Firmware Updates and Downloads

Snapmaker 2.0
11

Sep 1 2020: Snapmaker2_V1.10.1

Thank you for your suggestions on how to make the Snapmaker 2.0 better. Here comes the latest version of the Snapmaker 2.0 firmware. Your feedback is always appreciated.

Changelog:

Main Controller

Bug Fixes

  1. Fix a bug where the machine stops at 99% when 3D printing.
  2. Filament would extrude properly after resuming from Pause or Power-Loss Recovery.

Improvements

  • Thermal protection is optimized to avoid accidental triggers.
  • Confirm if Power-Loss Recovery is normal during controller bootup.
  • Pre-heat the nozzle to 150℃ before it raises up from the print after resuming from Power-Loss Recovery.
  • Lower the initial height of the nozzle after Auto Leveling.
  • Raise 3mm for the initial height of the nozzle in Manual Leveling.

Downloads:

Snapmaker2_V1.10.1

MD5: 6addea2ecc4a06ed07c138dfa4b3a502

Notes:

This firmware update is only compatible with the Snapmaker 2.0 devices.

You can check the About page for the firmware version after the upgrade.

How to update Firmware

  • via a USB flash drive
    • Put the firmware update file Snapmaker2_V{version}.bin in your USB flash drive.
    • Plug USB into the USB slot of the Controller.
    • On the touchscreen, tap Files , select the update file under the USB tab to start the update.
  • via Wi-Fi
    • Tap Settings -> Firmware Update on the touch screen.
    • Read the changelog and download the firmware.
    • After the firmware is downloaded, click “Update Now” to start the update.
9 Likes