hi, have done some laser and cnc (worked well)
enclosure was delivered (so that is the only thing new) and refuses to cnc saying the door is open (which it isen’t) “enclosure recovery program” “the door is open…”
have tried swapping the cable around and
changing the enclosure door in settings - was “off” to start with, and if i tried to turn it “on” and press “save”, it switches back to “off”
don’t know if this is relevant - but the fan or the lights have not come on, i assumed they would come on when the job started.
i can move the cnc module and the wasteboard, but the job just wont start.
have put the enclosure on 4mm pads (4 corners and one under each foot of the snapmaker (to save the table from being scratched)
any help appreciated (i am at a loss)