I’m having some severe problems with my z-offset and my dual extrusion module. I downloaded the 2 color benchy and was able to alight it properly in luban and scale it up to 2x the normal size. I assigned L to a green PLA and R to a yellow PLA, both based on the standard PLA presets. I ran auto z…

Download the log. It has plain text and might give you a clue. I would reload the firmware from the usb… sounds like something is messed up.

make sure to check mechanical issues. The system is really sensitive to drag. [image] Dual Extruder design / Dry box setups Snapmaker 2.0 This is a description of the issues you may have if you have an elaborate dry box, Bowden tube setup that worked with your old single…

The entire unit moved up, not just the head. The Z axis itself moved significantly. And after my update it wasn’t extruding anything at all, but if I go back and do one of the tests, it starts printing stuff again.

Solved it. Too much friction with the filament and tubes were pulling the nozzle in the air. Installed the snapmaker dual holder and the tubes… worked just fine. Fun fact, if your bed sensor fails on this guy it’ll just map itself in the air. Only way to get around it is to disconnect it…

Severe Issues with Z-offset and Dual Extrusion

Snapmaker 2.0 (3-in-1)

Spaced April 2, 2023, 3:43pm 3

make sure to check mechanical issues. The system is really sensitive to drag.

Topic		Replies	Views
Dual extruder printing in air on second layer Snapmaker 2.0 (3-in-1)	9	945	February 6, 2024
Double extruder not switching heights correctly Snapmaker 2.0 (3-in-1)	11	931	March 25, 2023
ABL Help needed please! Snapmaker 2.0 (3-in-1)	7	1396	January 27, 2021
Dual extruder set up Snapmaker 2.0 (3-in-1) Dual-extruder	12	698	February 7, 2024
Dual Extruder loses Z axis position on extruder change Snapmaker2.0 Troubleshooting guides	13	132	February 15, 2026

Severe Issues with Z-offset and Dual Extrusion

Related topics