So I have decided to create a new post as I have never really enjoyed my 3d printer and frustrations are at full level now. Hopefully everyone can pitch in and help unravel this mystery. So after posting on several groups and even DM-ing people that helped, couldn’t really get anywhere. Meanwhile…

I guess so,maybe this time I need someone to show me how a fish looks so I could learn how to fish :))

If you share the last picture model and gcode we could compare the prints.

@xchrisd Thank you very much. So I was thinking at this : abucheo fantasma by elChivito - Thingiverse , scaled to 50% so it’s not to much bother My g code: 8nHTEWzw3B5 50%.gcode (3.4 MB) My prusa settings, hopefully this is what you need PrusaSlicer_config_bundle.ini.zip (4.6 KB) My M503 M503 …

So it finished… I will be honest, I haven’t watched it… just hit start… The bottom seems a bit rough… My bed might be warped… Need to see if it’s covered by warranty:( [PXL_20230818_220232596] Then overall print [PXL_20230818_215932120] [PXL_20230818_220114602] [PXL_20230818_220140106] [PXL_…

I’ll admit, that model is flawed:)) I’ve done a calibration cat as well, from thingiverse [image] Cali Cat - The Calibration Cat by Dezign Cali Cat is designed to be the purrfect initial calibration and benchmarking print. It is a simple, standard test to ensure you have the basics dow…

Small prints should not be problematically but over all, here you go: [image] A350 Bed rises and falls even during slow speeds Snapmaker 2.0 Here is a video. Watch the corner against the Z arm, and it’s quite noticeable it goes up and down. Am I the only one seeing thi…

@xchrisd I need to see if this doesn’t void my warranty, and to be honest not sure if this is the case… I don’t want to fall in a rabbit hole where I think the universe is plotting against me :))… Not even sure if it’s a rail issue… Watched the video few times and I see a jitter… But I might be bias …

@Marius87bv The cat is overheated or not cooled properly…

Bet the plate shifted mid print, the embedded heating coil has about a 20 deg deviation where the probe reports but the bed sheet is about 5 minutes heating time behind, cause many print shifts when I first started, almost made me pull my hair out

@Rwide Is it something I could do about this? The fan is at 100%, tbh, never really messed with cooling

3d printing problems I have

Snapmaker 2.0 (3-in-1)

xchrisd August 19, 2023, 5:40pm 48

Small prints should not be problematically but over all, here you go:

Topic		Replies	Views
Please help, I don’t understand what setting I need to adjust Snapmaker Luban	71	1919	March 25, 2023
Any advice on strange issue? Snapmaker 2.0 (3-in-1)	13	1082	February 5, 2024
3D Printer Under extrudes or not at all Snapmaker 2.0 (3-in-1)	32	5785	August 27, 2020
3D printing gone crazy Snapmaker 2.0 (3-in-1)	36	623	January 4, 2025
What Problem is this? Showcases & Tips	50	1991	September 14, 2024

3d printing problems I have

Related topics