New and HIGHLY UNHAPPY user of a J1

Snapmaker J1/J1s
2

Hey @kdfjgka, hmm where to start, here are the latest and previous Luban versions for download:

Here is the firmware location if needed:

I don’t heard much about slicer problems, there are snapmaker provided profiles:
The official link of snapmaker page for cura (but it’s available in cura add on store too) :
https://github.com/Snapmaker/SnapmakerCuraPlugin/releases/download/0.9.4/SnapmakerPlugin-0.9.4.curapackage

Other profiles are available directly in the slicer or in the forum, I can’t catch them now it’s hard surfing around with the phone…
It seems you already found this?

And even a great wiki which could help you (including the quickstart guide):
https://wiki.snapmaker.com/en/snapmaker_j1

Be sure you could reach out to support and they will help you:
https://snapmaker.formcrafts.com/support-ticket
Or support@snapmaker.com

If you describe your problems nearer maybe some other J1 users jump in and assist you.
Basically I am a user like you but have a 2.0 and no J1.
Hope this helps a bit, don’t hesitate to describe your problems here.

2 Likes