it is nearly impossible to print flexible filament such as TPU with the default hardware. I have made an adapter that makes it easier. If this piece was incorporated into the heat sink inside the 3d module i think it would be a nice improvement to the filament feed. If they so desire the snapmaker t…

@jjestings 6/6 prints successful after adding your modification, printing 2 large pieces overnight, Nice work buddy :+1::+1: @stickyiggy do you use the modification/adapter printed from ABS? I ordered the adapter from shapeways made from metal. But since adding it to the printer, printing TPU is …

It does not make much sense to force the melt through the nozzle when it is too cold to bond with previous layers. Es ist nicht sehr sinnvoll das Schmelzgut quasi mit Gewalt durch die Düse zu pressen, wenn es dann zu kalt ist um sich mit vorherigen Lagen zu verbinden.

Even with jjestings small adapter i was never able to do a single print without failure when using filaflex filament ( https://www.filamentworld.de/shop/filament-3d-drucker/filaflex-filament-1-75-mm-schwarz/ ) The problem with the snapmaker extruder is, that flexible filaments are pressed inside the…

Hello @Henning , I find your design to be very interesting, I download it and I´m trying to print it in PETG, I wonder if this is going to work or the temperature from the nozzle will make it all soggy and jam my snap maker. I don’t know if you have any particular instructions to install it, I will …

This has been nothing but a nightmare and of course JJ is not free anymore. I am going to try out Hennings and see what happens.

I tried and tried and tried again with and without the other adapter, with no results. Put this bad boy in and boom! Perfect! Thank you so many times over! This made may whole week!

you’re welcome :slight_smile: ! could you share your settings for printing with flexible filaments? For the moment i working with filaflex from filamentworld thats seems to be more of a tricky one compared to other flexibles?!

basically, you have to disassemble the whole thing, and put it back together… so no instructions needed :slight_smile: but i suggest to take a pic for every step. shrinkage of the material you’re using should be taken into account to get the part fitting without blocking the button/extruder mechani…

Certainly. I forget which brand I bought, but I can check when I get home. The type of filament was tpu though. My settings were created by duplicating the high quality print, then adjusting accordingly: Print bed temp: 80 degrees Same for initial layer print Printing temp: 250 Same for start an…

So, I went to print again, and it got jammed after a few minutes. I made the following adjustments, and it is printing well again: Initial temp:240 Printing temp:235 Final temp:235 Heated bed:80 for both still Flow:90%(May or may not be necessary) Slowed all of the speeds from the “High Qualit…

Flexible Filament adapter is needed

Snapmaker 2.0 (3-in-1) Snapmaker2.0 Troubleshooting guides

xchrisd August 4, 2020, 5:06pm 71

Topic		Replies	Views
Printing TPU with A250 (or any SM 2.0) Snapmaker 2.0 (3-in-1)	131	31051	February 26, 2023
Experiment with TPE filament Showcases & Tips	4	3836	August 29, 2019
Loading TPU difficulties Original (3-in-1)	3	875	December 18, 2023
3D Printer Under extrudes or not at all Snapmaker 2.0 (3-in-1)	32	5728	August 27, 2020
Flexible Filament Snapmaker 2.0 (3-in-1)	10	2723	March 10, 2022

Flexible Filament adapter is needed

Related topics