Ran a 40+ hour print. It got to 98 percent, and then I started getting messages filament needs to reload. Well, it’s not out of filament. I cut the filament and reloaded it, and the message keeps happening even though I get flow during the reload process. Eventually the nozzle just face planted …

Solution: CONTACT SUPPORT BEFORE YOU PROCEED. THIS MAY VOID YOUR WARRANTY. Remove fan: [Dismantle the sideboard] Repair filament switch: [filament switch fix] Profit?

@sdj544 Yes, Edwin has left. Now there are several supports in the forum actually. We will try our best to provide services in the forum.:blush:

My out of filament micro switch on my A350 went bad. I see no sense in buying a whole print module. Can you give me the part number of the switch so i can just replace the switch?

@Fehlingd1 They seem to have a proprietary switch for this application. I have tried to find a replacment, and while I was finding some that were smaller than most, it still didn’t fit. The same switch is located (soldered to a PCB I believe) inside of the linear modules if you have a bad one of t…

Thanks… Didnt they advertise no propriety items? If I find one I will let jou know… Da

Not that I am aware of. Proprietary may be a harsh word, someone may have it in their catalog, but its certainly an unusual sized switch.

The Omron D2F-01L was close as I was able to get, can’t remember if it’s been confirmed to work or not work, but I think the dimensions match up. [image] Excessive play in x-axis linear module bracket Snapmaker 2.0 [image] [image] Linear actuator end s…

Any idea what the subcomponent switch is in that assembly? Preferably a part number that can be ordered from digikey or mouser and soldered on?

From all the research I’ve done on this I’ll propose this as the full specification for the filament runout switch: 12 x 6 x 6mm, SPDT, Microswitch, Simulated Roller Lever, Snap Action For the linear modules instead of “simulated roller lever” it would just be a “hinged straight lever” The switch…

They didnt have all of the various flavors on newark in stock and i didnt wana screw around much so i got one of the first style of simulated rollers and one straight blade My switch in my hand is measuring closer to 5mm than 6 mm in the two directions but it might just fit, we will see …

Filament reload... Wait, it's not out of filament

Snapmaker 2.0 (3-in-1)

brent113 July 21, 2021, 9:59pm 113

The Omron D2F-01L was close as I was able to get, can’t remember if it’s been confirmed to work or not work, but I think the dimensions match up.

Topic		Replies	Views
Loading filament problems Snapmaker2.0 Troubleshooting guides	66	8359	March 12, 2019
A150 first print stop due filament runout recovery Snapmaker2.0 Troubleshooting guides	5	2000	March 16, 2023
Filament reload Snapmaker 2.0 (3-in-1)	8	1152	October 10, 2020
[GUIDE] Octoprint + (stock) Filament runout detection Snapmaker 2.0 (3-in-1) wiki	10	779	March 27, 2026
A350 printing "into thin air", no filament extruded Snapmaker 2.0 (3-in-1)	77	6633	March 9, 2021

Filament reload... Wait, it's not out of filament

Related topics