When I run the calibration procedure on my new A350 all of the test points are offset to the left and forward of the center position on the printed grid by about 15-20 mm. When I ran a couple of test prints they were similarly not centered on the bed. I’m pretty sure my bed is assembled according to…

Bump. I just received my A350 and I have the same issue. The bed cant level because the nozzle is off the bed on the left side.

The sensor is to the right of the nozzle. Is the sensor off the bed or just the nozzle? -S

I went to take a picture of it this morning, and it kept the nozzle on the bed all the sudden, but was still very off-center. I will try and get it to print and report back.

I am having this issue as well - bump

Share photos and settings and/or screen captures or we can’t help you. -S

I just received my A350 yesterday, and have the same issue. The calibration (auto or manual) is consistenly off to the left, and the z-axis adjustment at the end does not occur at the ‘center’. I see no way to adjust this.

The nozzle itself is not the point that is measuring, the sensor is off to the size, so this is why.

Auto calibration was not working, so I am trying manual calibration. How do you perform the paper height test when the nozzle is not even close to the build platform? In the photos, you will see the ‘manual calibration’ touch screen, and the position of the nozzle when attempting to measure the fi…

Look at your last photo, and mount your Y modules correct it seems not beeing so. Check over the hole build!

Centering Issue

Snapmaker 2.0 (3-in-1)

MooseJuice March 4, 2021, 9:24pm 11

Agreed, your linear modules are not mounted to the base correctly, they are supposed to fit in that rectangular groove

Snapmaker 2.0 bed levelling issue - Snapmaker 2.0 - Snapmaker: where creation happens

Topic		Replies	Views
Print head not centered Snapmaker 2.0 (3-in-1)	23	2399	January 4, 2021
Auto-leveling is...wonky Snapmaker2.0 Troubleshooting guides	18	2823	December 29, 2020
Auto level calibration is off center Snapmaker 2.0 (3-in-1)	3	1191	April 4, 2021
A350 Auto leveling issue? Showcases & Tips	4	594	December 17, 2020
Bed too far back for first 3 calibration points Snapmaker 2.0 (3-in-1)	9	1015	September 9, 2021

Centering Issue

Related topics