HI! so i got my new snapmaker 2 A150 and follow all the instruction to set up the printer now i try to make a test print of the vase from the luban and after 1 layer of print i got a massage of filamnent runout recovery… offcurse i dont need to replace and i tried to unload and load the filment a…

Here is what you are looking for: [image] Filament reload... Wait, it's not out of filament Snapmaker 2.0 Hi, here is Liu from Snapmaker Team. When the touchscreen tells you “out of filament”, you can click “cancel” or “ready to load”. Please make sure that the end of fi…

Here is Edwin from Snapmaker Team. Did you encounter this “filament runout” issue? How about the frequency? Next time the warning of “filament runout”. You need to connect the machine with the PC and then launch Snapmaker Luban. Enter command “M119” in the console and operate it. You can refer to…

update: hi again , so back at that time i used the command M119 and printing was good and sucssed, i have to say that i only done 2 prints with this command , and then i had a lot of project to work for school so i didn’t touch the printer since then, until now… (and i even didn’t check the CNC and…

Hello. I recently had two 3D modules report filament runout errors that could not be fixed but reloading. (I have several snapmaker machines). Obviously the sensors were problematic. Therefore I read the information in the forum and in the Snapmaker guide. I was able to repair the sensor on one by …

I guess there is a setting on the touchscreen to deactivate runout protection. Settings - 3d Print :wink:

A150 first print stop due filament runout recovery

Snapmaker 2.0 (3-in-1) Snapmaker2.0 Troubleshooting guides

xchrisd May 21, 2020, 4:30pm 2

Here is what you are looking for:

Topic		Replies	Views
Filament runout recovery fix status Snapmaker 2.0 (3-in-1)	9	1554	November 11, 2023
Filament reload... Wait, it's not out of filament Snapmaker 2.0 (3-in-1)	125	11896	March 13, 2024
Filiament Runout Recovery Problem Snapmaker 2.0 (3-in-1)	1	423	September 7, 2022
Snapmaker A350 3D printer issue Snapmaker 2.0 (3-in-1)	9	1420	June 4, 2021
Filament reload Snapmaker 2.0 (3-in-1)	8	1156	October 10, 2020

A150 first print stop due filament runout recovery

Related topics