Snapmaker and Lightburn

[xchrisd]

I would suggest to read @Skreelink s guide:

Full Lightburn Control Guide

So… After a lot of testing… It’s been awhile since I’ve done a guide, and this one was a long time coming. This guide will allow you to do your entire project in Lightburn, and (if connected via USB) run it directly from Lightburn. Letting you skip Luban or using the USB drive entirely. A quick note, this guide, like most of mine, will assume you have some experience with the machine. As always, feel free to ask questions and I’ll try filling in any gaps you find. I’ll be posting the setup I u…

Note: The modded firmware is not needed anymore cause of new functional firmware release from snapmaker.

Didn’t use lightburn yet…