Snapmaker 2.0 a350 enclosure

[Edwin]

@Orbnotacus

Once it was done, I turned the machine off, plugged the enclosure into the controller, then turned it back on. The touchscreen then told me my “enclosure module firmware” was out of date. Nothing on the site about it. Enclosure fully functions except I can’t turn on “Door detection”. As soon as I click “save” in luban, it reverts back to “off”.

I think you have updated the firmware to V1.12.0. As I wrote in this article, you need to upgrade the firmware with three tool-heads one by one.
[ Upgrade the Toolheads Separately with Snapmaker Firmware V1.12.0

Best regards
Edwin