Rotary disappointments

[brvdboss]

I did a small write-up of my Fusion experiments with the rotary module so far:

Rotary Module with Fusion360: It works! (good enough)

Hello, I was hoping to show this little thing that had come to life on my rotary module. [image] Especially with the engraving added to it: [image] I didn’t try creating it in Luban as I had my doubts that the engravings would come out nicely, so I figured why not try and convince Fusion360 to work with the rotary module. As then I could project have a real engraving onto the curved surface. (which isn’t just a cylinder or something. Unfortunately, it ended like this ( I was so close…): …

I was hoping it would have been more of a success story, but I needed to document it so I wouldn’t forget it myself either, so I decided to make it a post
(and I think it deserved its own topic)