Hello, I had this issue for almost a month now, I FB massage Jade Wu but got no reply My SM 350 2.0 can’t not detect that I have a quick swap kit, I set it that I have it and click don’t ask me again and I go in again to check if it recognized that, but it doesn’t , consequently I can’t calibrate …

No issue here, using firmware Snapmaker2_V1.16.7_20230727 and Luban 4.8.2. You need to make sure you also enable the Quick Swap Kit in Luban’s machine settings. Since there is no way the machine could hardware detect the kit, I cannot imagine that the controller setting would “reset” itself, since i…

Here you go: [image] Quick Swap kit is saying it is not installed Snapmaker 2.0 Having got my QSK, promptly installed it. Mounted the DX…all good. Was on 1.16.7 firmware already, so no update required, hence just went to tell the machine that the QSK was installed on the…

The is simply a bug in the quick swap status screen…even though you have selected Installed, it looks like it has reverted back to Not Installed if you go in there again. SM Support have confirmed this to me. You can look on the home screen on the touchpad, and it WILL show installed…so you are all…

Quick swap install status keeps not detecting my quick swap kit

Projects, Tips & Mods Showcases & Tips

xchrisd September 30, 2023, 3:01pm 3

Here you go:

Topic		Replies	Views
2.0 250 Can't save presence of instaled quick swap kit Snapmaker 2.0 (3-in-1)	1	43	December 22, 2024
Quick Swap kit status - need to set it all the time Snapmaker 2.0 (3-in-1)	11	591	June 4, 2024
Cannot Calibrate After Quick Swap Kit Installation Snapmaker 2.0 (3-in-1) Accessories , Dual-extruder	1	567	October 21, 2023
Quick Swap kit is saying it is not installed Snapmaker 2.0 (3-in-1)	4	563	September 22, 2023
Quick swap kit calibration issue Snapmaker 2.0 (3-in-1) Accessories	3	576	November 8, 2023

Quick swap install status keeps not detecting my quick swap kit

Related topics