Nozzle for Smaller minature prints

The actual swap isn’t very challenging, but you might need to recalibrate and make some changes to your print settings. You will need a difference slicer, because Luban doesn’t allow you to change the nozzle size. If you don’t have an favorite, Cura is pretty easy to pick up as it works much like Luban.

Most people looking for alternate nozzles buy them off Amazon. There are a lot of forum posts about larger and harder nozzles for various reasons.

There are a couple posts on the forums:
Problems with 0.2mm nozzle
0.25mm nozzle profile