Machine has been properly assembled and cables all appear properly connected. I am forced into the set-up process when I power on and it fails in the auto leveling step. The print head comes down and digs into the plastic print mat, tries to moves through the first positions, and then retreats half…

Problem solved. The prior owner had the X and Y converter cables backwards. That explains why the unit was never used!

Newbie with used A250 - Can’t Calibrate

xchrisd November 10, 2023, 7:49pm 4

Does your proximity sensor light up when triggered?

Topic		Replies	Views
Help with new A350 not having correct 3D print origin Snapmaker 2.0	5	447	May 6, 2022
When I try doing an 5x5 grid calibration the print head goes past the back of the print bed Snapmaker 2.0	15	1098	October 4, 2020
Auto level calibration is off center Snapmaker 2.0	3	1177	April 4, 2021
A350 Proximity sensor not working? Snapmaker 2.0	23	2877	September 21, 2020
Initial setup failed Getting Started	4	389	October 4, 2020