Hello Together I wanted to deal with the LaserModule today. However, I have the feeling that my Laser Cutting Platform which I have received are drilled incorrectly cut. Does anyone also have such problems? Or anyone have a tip on what I’m doing wrong? [20201225_185040] Modell is a Snapmaker 2…

And the outer plates are not center drilled and have to be rotated if it doesn’t fit.

Assemble it like this [image] Laser Platform setup Snapmaker 2.0 Hi @Edwin , @FlyByWire ’s laser platform and mine look identical. Here’s mine: [image] Are we saying that’s not the correct pieces? Would that explain why I had to shim them with tape under the middle two?…

I think the half screwhols belong to the middle, so did I.

Yes its different from the build manual. The 2 pieces with half a hole go together in the middle to complete a hole, and the two with 4 complete holes go on the outside. Using a total of 14 screws for the whole bed, not just 8 across the middle, well I did anyway.

Mounting Laser Cutting Platform

Snapmaker 2.0 (3-in-1) Snapmaker2.0 Troubleshooting guides

brent113 December 25, 2020, 8:02pm 6

Assemble it like this

Topic		Replies	Views
Laser Platform setup Snapmaker 2.0 (3-in-1)	11	2664	December 9, 2020
Can't build laser bed Snapmaker 2.0 (3-in-1)	5	575	December 18, 2020
Uneven laser platform Artisan (3-in-1) Laser	9	646	December 18, 2023
Number of Screws for the Laser Engraving Platform Snapmaker2.0 Troubleshooting guides	2	795	September 14, 2020
Sandwich laser platform Snapmaker 2.0 (3-in-1)	4	154	May 5, 2025

Mounting Laser Cutting Platform

Related topics