Layer shifting to right

[xchrisd]

@xchrisd

Do you have the 8/20mm lead rails or the old 8mm?

If you have old linear modules this could be a disalligned thermal silicon pad, unfortunately I can’t find the guide for this…
Here is a linked video, the pad is visible on 18sec.

Still can't believe all these layer shifts - RESOLVED as Slicing Issue

The cooling of the linear module stepper drivers is done by the metal housing, to which they thermally connect the driver chip with a silicone pad. There are reports where they forgot to put that pad on the chip. I think it should look like at ~10s into this video: Snapmaker Linear Module Repair - YouTube

Here is how to disassemble:

What should I do when the slider of the Linear Module comes loose?