Laser Not Burning, Calibration Fails

[xchrisd]

Hey, i guess your enclosure-door (have you?) makes the problem.

Some info´s about the enclosure and door detection:

You have to deactivate door detection every power cycle.
If you turn the door detection off in Luban, it is off in Luban, not off in the machine.
If you turn the door detection off in the machine settings, it is off if you use the touchscreen, not off in Luban.

You just switch the human interface, its the touchscreen or Luban, to control the machine.

Have a look at your door magnets:

Door Detection Faulty

Here is a picture of the door magnets, I am not sure what picture did you request? [15973058406594161735532706239798]

You could check the door state by M1010 if you are connected with Usb to Luban.

Something to read:

Laser Autofocus Failure - No Laser Beam

Trying to set up to do my first laser engraving, but when I go through the calibration procedure that appears the first time I use the laser I get to the point where it’s supposed to engrave a set of lines on the material and the beam is so dim, so low powered, that it can’t engrave anything on the material. There’s no power adjustment during any of the previous screens to turn up the power, and trying to swipe left to bring up the control settings isn’t available yet. Suggestions? I watched th…