10w laser doesn't burn anything. Any idea?

Snapmaker 2.0
1

Hi All,

Finally I got my x axis fixed and the machine is runnuing in general. I am using 10w laser and I tried using laser ruller eample in luben and I put 1.5mm sheet of wood and after running the job I do not see any buring. I did calibration first putting the card etc. Any idea?

thank you

Andre

2

Hi Andre, it may be that your door detection limits the laser intensity. Can you verify the door state? Sometimes the magnets triggering the door sensors misalign or fall off. Some more read about this: Warning: Security issue - Enclosure door detection not checked at start/not fail safe

3

Thank you so much for suggestion. This was the issue.