Either the magnet on the front folding door is incorrectly placed or the magnet on the 24 beam A350-3 is. The door does not magnetically close. In this image, you can see the magnet on the door is too low to attach to the magnet on the door. [sm350enclosurelatch]

The magnet inside the door handle is placed wrong. I think it’s just secured with adhesive. You could always try to get it out of there clean up both surfaces, get fresh 3m tape and fix it’s placement. I don’t understand how this causes unsafe working conditions like you say though.

Door must close for the sensor not to trip. when using laser or cnc.

You CAN turn that off, but it’s not a hazardous situation. I suggest fixing the magnets placement though.

[image] 3D and Laser modules no longer working Snapmaker 2.0 We used a small magnet to trigger each sensor individually and marked with a sharpie on the sensors. Magnet locations: [image] Left side sensor locations: [image] Right side sensor locations: [image]

That magnet is used to secure the door when you need to close. In your picture, the door’s magnet does misplace. You can contact support to see if they can help you with it. support@snapmaker.zendesk.com Also, you use the hair dryer to heat it up and then reglue it.

Incorrect magnet placements on A350 enclosure cause unsafe work condition

Snapmaker 2.0 (3-in-1)

brent113 June 8, 2021, 10:47pm 5

Topic		Replies	Views
Door Detection Faulty Snapmaker 2.0 (3-in-1)	36	3229	January 3, 2021
Issues with door detection on second-hand enclosure Snapmaker 2.0 (3-in-1)	4	92	January 16, 2025
A350 Enclosure Configuration Snapmaker 2.0 (3-in-1)	11	888	March 14, 2022
Swapping wall locations on A350 enclosure Snapmaker 2.0 (3-in-1)	2	908	December 17, 2020
Enclosure Door Sensor Snapmaker 2.0 (3-in-1)	3	1305	August 9, 2021

Incorrect magnet placements on A350 enclosure cause unsafe work condition

Related topics