Hello All, I hope everyone is having a wonderful day :slight_smile: I will be putting the A350 together tomorrow (very excited!) and figured it couldn’t hurt to prep some calibration materials. After fooling around on https://teachingtechyt.github.io/ for a while, I found that the default setting…

Start here: [image] Snapmaker 2.0 Initial Calibration Settings / Experiences Snapmaker 2.0 Hello all, I thought I’d type up my setup and calibration procedures for future reference since I haven’t seen too much of this information in a single place before. Hopefully this …

I read through both of those before posting initially but each left me with a lot of questions. Most of the questions I have been able to figure out but I thought some people might just have some gcode for the a350 for things like the temperature tower. If I’m tuning settings in Luban, they won’t m…

Teaching Tech presliced everything in Simplify3D. Since it sounds like you have a desire to make everything match then you either need to a) use Simplify3D after calibration or b) slice the calibration models yourself in Luban. However, if you just try it instead of fussing over these minute detail…

Gotcha. So you’re saying I should just input all the settings I can change to match and try get glean info from the print(s) even though it won’t match perfectly? It seems like people prefer using Cura over Luban. Should I just not use Luban unless needed?

[image] Printing4Good: So you’re saying I should just input all the settings I can change to match and try get glean info from the print(s) even though it won’t match perfectly? Yep, and I think you’ll find you get good results. Really, the main things people need to change are calibrating e-…

The settings are no longer required for Cura, as the latest version of Cura has Snapmaker 2.0 in the database. You just have to choose your printer. The supplied profiles are well suited for getting started.

Thanks! After installing Cura, using the default settings it gives for the A350 (pic of those settings attached), and printing a few cubes, boats, and temp towers, there are three problems I’m having despite messing with settings (relevant pics attached). It drags over the prints and leaves a ma…

That honestly looks pretty good. Not perfect, but better than many printers. [image] Printing4Good: It drags over the prints and leaves a mark on the top Some prints have some noticeable stringing Every once in a while a layer will have a blob or be a tiny bit off in one or two spots. Cou…

Calibrating the A350

Snapmaker 2.0 (3-in-1)

sdj544 November 2, 2021, 7:43pm 2

Start here:

Cube and benchy are both good first things to print.
-S

Topic		Replies	Views
What are the rules of thumb with various calibration and 3D print settings in Luban? Snapmaker2.0 Troubleshooting guides	21	5771	January 7, 2021
Snapmaker 2.0 Initial Calibration Settings / Experiences Snapmaker 2.0 (3-in-1)	46	21466	December 20, 2022
ABL Help needed please! Snapmaker 2.0 (3-in-1)	7	1424	January 27, 2021
First-time printing Snapmaker Luban	10	1613	May 23, 2021
I print 0.2 mm smaller than the solid measurement Snapmaker 2.0 (3-in-1) 3D_Models	21	427	July 17, 2025

Calibrating the A350

Related topics