Brand New to 3D Printing - 37 hour printing time normal?

[xchrisd]

Hey @demoniousrex, welcome!

For the vase, there is a quality profile for it, its called “caselibrary.vase.AXXX.quality”.

For future questions it would be nice to have a gcode+stl, maybe also a picture (the 3d object you want to print), so please upload it.

In this special case, you want to print a vase.- There is a preference under “Surface”, this is called “Spiralize Outer Contour” see the screenshot:

The print with this profile needs about 4hours.

Generally i would say, its a lot of trail and error learning 3d printing.

My favourite settings are:

• layer height of 0.2mm (looks nice enough for my most prints)
• initial layer width 120% (to get better adhesion)
• initial layer speed 8-12mm/s (cause of adhesion problems of my unflat bed)
• layer speed about 40mm/s (depending on the wanted quality)
• wall thickness 1,2mm (depending on the model)
• top bottom thickness 1,2mm (same)

Here is a useful thread which may also helps you in the future:

3d Print Guide_Walk Through

First of all, congratulations to a great machine! If you have any suggestions to this topic, feel free to send me a PM! You are new to 3d printing?- Be patient. The whole thing is very complex and just little adjustments will make the difference from failed to pretty prints. Start with easy, little things to create (1-3hours i would suggest) . Going to print the first time and then getting a 24h print on, maybe failes. There is a lot to learn, if it didn´t work for a long time, cool off a bi…

Hope this helps!
Feel free to ask again