I think I have all the updates installed, and everything was going well on my CNC project (the one that came with) until I shut the enclosure and reopened it a bit later to check on progress because it’s hard to see thru. I told the machine that it was ok to resume, (assuming it knew where the origi…

This is what you are looking for: [image] Touchscreen is black Snapmaker 2.0 Hello, got the answer from the snapmaker support today. The Problem was the rubber at the cable connector to the touch screen. We cut of 1mm of it. [image] It worked immediatly! Thanks for y…

You already have another thread going with related problems. You’ll get better help if you don’t start new ones. Doubtful that you hurt your toolhead just by crashing it. Most of us have done it pretty hard and repeatedly. Try giving it a minute or two for a reset. Other questions answered in you…

I just had the same problem. No doubt you have fixed it by now. I think it is the poor connection design for the plugs, esp with the cable for the screen next to the usb port, and all hitting the enclosure. Also, the connection for the screen doesn’t seem to lock in, like the others. It is quite loo…

So, maybe cutting some of the ‘plastic’ from the connector may help? It is really loose

Won't stay connected, touchscreen won't stay on

Software Snapmaker Luban

xchrisd November 16, 2024, 8:46pm 5

This is what you are looking for:

Topic		Replies	Views
Touchscreen not responding Snapmaker 2.0 (3-in-1)	3	89	December 6, 2024
Touchscreen flex cable plug end remained in the controller when disconnecting Snapmaker 2.0 (3-in-1)	3	563	July 14, 2021
Touch screen inoperable/blank when turning on the machine Showcase & Prints	2	67	December 15, 2024
Firmware update help Snapmaker 2.0 (3-in-1)	20	449	November 22, 2024
Touchscreen is black Snapmaker 2.0 (3-in-1)	8	867	February 22, 2022

Won't stay connected, touchscreen won't stay on

Related topics