Hello together i printed a part of a glove and i had similar cases where this happended but not as worse as it is with this part [image] Looks like it extruded to less or nothing the material is very weak in this area what can i do to avoid this? Thx for every tipp

Underextrusion possibly, the link @ElloryJaye posted is the original link and its cluttered, here’s the cleaned up summary one. Summary: Extruder calibration a must

thx for the reply but I calibrated the e-steps multiple times now. but I will check it again to be sure

If your e-steps are calibrated, then it’s probably moist filament

Hm ok since i opened the filament it was in a filament box with 10% humidity. So it should be ok

Could be the filament is binding on the z tower. Could be there’s a partial clog. You could slice just that section of the model and watch it print to learn what’s happening.

Just because you had it in a box that was down to 10% humidity, does not mean it wasnt humid when you opened it. I open brand new freshly sealed spools (even the good stuff like Matterhackers, even matterhackers pro which seems packaged worse than their build line for some damn reason) and they are …

@brent113 im using the filament guide that should be ok but im looking for a better solution. I will check the nozzle as well! @MooseJuice yeah i heard that even new filament can alredy be moised. And no the box does not heat.

I would even guess partial clog, underextrusion or filament grinding because of excessive retraction moves. Try a retraction of 1mm@45mm/s or 60mm/s if you slice with Luban.

The retract was set by 0.6 mm a 60mm/s and i sliced with cura

What Problem is this?

Maker Creations Showcase & Prints

ElloryJaye May 22, 2021, 3:01pm 2

Could be underextrusion—not uncommon if you’re still using factory settings. Have you calibrated your e-steps? Extruder Calibration a must

Topic		Replies	Views
3d printing problems I have Snapmaker 2.0 (3-in-1)	88	2479	August 31, 2023
Uneven laying - filament related? Snapmaker 2.0 (3-in-1)	17	1346	November 12, 2020
Please help, I don’t understand what setting I need to adjust Snapmaker Luban	71	1973	March 25, 2023
Printing quality - lines printed Snapmaker 2.0 (3-in-1)	49	3282	June 4, 2021
Any advice on strange issue? Snapmaker 2.0 (3-in-1)	13	1093	February 5, 2024

What Problem is this?

Related topics