Struggling getting full use of printed area (A350)

[Mxbrnr]

Just recently had this same discussion with another user. Here is the link to what I told them; the same applies for you.

Platform tilts when it accelerates in Y direction

This is the notorious z-wobble of the Y-axis linear rails. It has been an issue for a long time, which Snapmaker has apparently refused to acknowledge, and is a fault in the design of the linear rail modules (it can eventually affect the X and Z axis modules as well). The underlying cause it that the bearings inside of the linear rail modules are loose and/or worn. There are 5 options to fix it: Contact Support to purchase replacement modules (expensive) Disassemble modules to tighten the bear…