May 7 2020: Snapmaker2_V1.8.0.0
Thank you for your suggestions on how to make the Snapmaker 2.0 better. Here comes the latest version of the Snapmaker 2.0 firmware. Your feedback is always appreciated.
Changelog:
Main Controller
New
- Added support for the enclosure.
- Added M1010 G-code for the enclosure.
Bug Fixes
- Fixed a bug where the controller doesn’t save current coordinates when there is a power outage.
Improvement
- Improved calibration for 3D printing.
- Added 5x5 calibration for 3D printing.
- Adjusted the initial Z height in Manual Calibration.
- Optimized G1029 G-code execution.
Touchscreen
New
- Added an option for 5x5 calibration
- You can find the option in 3D printing advance settings.
- We recommend that you should re-do bed leveling after changing the calibration settings.
- Added Enclosure APIs for remote control(Snapmaker Luban).
Bug Fixes
- Fixed a bug where the Save button isn’t greyed out during Manual Calibration.
Downloads:
Snapmaker2_V1.8.0.0
MD5(bin file): f4a6105f454baa7b68b72aa79e751903
Notes:
This firmware update is only compatible with the Snapmaker 2.0 devices.
You can check the About page for the firmware version after the upgrade.