Snapmaker 2.0 Firmware Updates and Downloads

Snapmaker 2.0
10

Jul 24 2020: Snapmaker2_V1.10.0

Thank you for your suggestions on how to make the Snapmaker 2.0 better. Here comes the latest version of the Snapmaker 2.0 firmware. Your feedback is always appreciated.

Changelog:

Main Controller

Bug Fixes

  • Fix a bug where the controller doesn’t enable wait-events after refactoring.
  • Fix a bug where a Z-Offset with a negative value can not be applied during the printing process or recovered from Power-Loss.
  • Fix a bug where the last G-code command might not be performed if printing from the touchscreen.

Improvements

  • Reduce the maximum Y position for 4mm to prevent the slider from hitting the end of the slot on the Y linear module for the A150 model.

Touchscreen

Bug Fixes

  • Fix a bug where renaming file extension will cause the file not to be displayed on the Files page.

Improvements

  • Unify print file source.
    • Now the touch screen will not trigger “finish print job” popup if a USB disk is disconnected from the controller.

Downloads:

Snapmaker2_V1.10.0

MD5: ececcc9e0b491f19f548616fb8bd23c1

Notes:

This firmware update is only compatible with the Snapmaker 2.0 devices.

You can check the About page for the firmware version after the upgrade.

How to update Firmware

  • via a USB flash drive
    • Put the firmware update file Snapmaker2_V{version}.bin in your USB flash drive.
    • Plug USB into the USB slot of the Controller.
    • On the touchscreen, tap Files , select the update file under the USB tab to start the update.
  • via Wi-Fi
    • Tap Settings -> Firmware Update on the touch screen.
    • Read the changelog and download the firmware.
    • After the firmware is downloaded, click “Update Now” to start the update.
4 Likes