Hi all! First post here! I was hoping to put together a set of standard calibration prints that I use for new filaments/spools of filaments to dial in settings with minimal prints required. I am looking to include a temp tower and test print for linear advance values but I am told that other users…

As you can see from this G-Code table for Snapmaker it doesn’t seem to use M900. [image] SnapMaker 2 Marlin 2 gCode Support Snapmaker 2.0 Hi Trek, thank you for your suggestions and we appreciate your input and here is the g-code reference file we have ready as of now for…

Im not entirely understanding your reply. From what I can see, the link is to the SM1 gcode reference file. What I dont understand is why it being missing from this reference file would mean that It would ignore a built in gcode command? When entering M503, I can see the linear advance value printe…

I think the M900 command works. The table shows modifications we made to original Marlin G-code, and most of Marlin G-code are supported in both SM1 and SM2. We will rearrange a new document as an official G-code reference on our website later.

Is anyone else seeing where the initial bed and extruder heat to temperature codes are being used but the Snapmaker 2 is ignoring all subsequent M104 and M140 codes in the files? I went as far as setting it up so they are reset at every level change and my SM2 A350 continued to print at the initial…

This is the exact issue I am talking about, the same happens for temp towers where the M104 and M140 commands are included in the gcode but the SM2 seemingly ignores these values and continues with the initial temps.

So what the real solution ?? How to print a tower temp on CURA with SNAPMAKER2 ? How to properly print K value test also ?

I have the same or similar issue. The printer ignores any nozzle temps in the start gcode and only takes the print temp it seems.

The only solution with the current firmware that I can figure out is to manually change the temperature at the correct time. A possible activity when it involves the initial layer and a change to the following layers, but with a layer tower that means staying nearby and watching for the correct tim…

I can now confirm it is the touchscreen controller parsing the gcode that causes the temperature gcodes and others to be ignored. I disconnected the touchscreen and setup Octoprint on a Pi 4 B and my same start code works as expected. I can now send the gcode directly from PrusaSlicer and start a pr…

DroneOn- Have you had any success in obtaining SM2 A series supported Marlin 2 g/M code from SnapMaker?

SM2.0 ignores certain gcode commands

Snapmaker 2.0 (3-in-1)

SchnabsiX February 7, 2020, 9:33am 2

As you can see from this G-Code table for Snapmaker it doesn’t seem to use M900.

Topic		Replies	Views
SnapMaker 2 Marlin 2 gCode Support Snapmaker 2.0 (3-in-1)	11	6127	December 27, 2021
Snapmaker 2.0 - A350 new machine Woes Snapmaker 2.0 (3-in-1)	12	2208	April 20, 2021
Snapmaker Calibration: Linear Advanced Tuning Questions Snapmaker 2.0 (3-in-1)	5	1556	February 11, 2022
What is "M2000 S200 V250 A6000"? J1/J1s IDEX	22	485	January 3, 2025
New to the Process: Calibrating the Machine Snapmaker 2.0 (3-in-1)	23	3606	May 3, 2021

SM2.0 ignores certain gcode commands

Related topics