Problems with Dual Extruder

[xchrisd]

Hope this helps:

Wedge:

[First Batch Shipped Out] FAQs of Dual Extrusion 3D Printing Module for Snapmaker 2.0

Hallo, @brewery.chump0x Klar teile ich es mit Dir / Euch. Anbei die STL und Auszüge aus der Mail vom Support an mich. Grüße —————————————- Hello, @brewery.chump0x Of course I share it with you. Attached is the STL and excerpts from the email from support to me. Greetings Block.stl (158.2 KB) [image] [image]

Dualextruder Door:

Dual Extrusion Head: Heat creep discussion thread

Hi all, so finally got around trying the new door design, and it was a full success! The model that failed after less than 20 mins before, now went through in 7 hours. The filament does not show any hint of broadening/heat creep, neither on left nor on right nozzle. Already informed support about the success, now waiting patiently for what they make from it - my assumption is that they’ll release a new front door and send this to those affected. I am curious how many this might be - would you m…