When Wifi connection is requested from Luban during 3D printing, a screen asking whether to start initializing the position appears on the Luban screen.
When a file is transferred via Wifi during 3D printing, a screen asking whether to start printing is displayed on the touch panel.
Therefore, it is not possible to transfer the print file as a preparation for the next operation.
There were times when the printer froze at the above two timings.
When I finish printing, I transfer the next print file via Wifi, and when I go to the printer, the screen shows the confirmation screen to start printing.
The filament cannot be replaced and the printer has to be restarted.
The file transfer via Wifi is triggering the touch screen to show the start of printing. This is very inconvenient and should be removed.