Power Module / 3D Printer Module /Linear Module

Blockmodule · December 14, 2021, 9:10am

github.com/Snapmaker/Snapmaker2-Controller

Fix Request: New linear module could damage machines

opened 07:51AM - 28 Nov 21 UTC

closed 10:53AM - 13 Dec 21 UTC

Firmware: Snapmaker 2.0

I would like to submit a fix request to GitHub with the following information. … If you build a machine with a new linear module (Read8mm/20mm, stamped on the side) in a combination other than the one shown below, nothing will appear on the controller display screen. If you build your machine with the new linear module (Read8mm/20mm, stamped on the side) in any other combination than the one below, nothing will show up on the controller display screen, and the axis will move on one side during homing, possibly damaging the two rails. Correct configuration X-axis: 1 x 20mm Y-axis: 2 x 20mm Z-axis: 2 x 8mm Wrong configuration will cause problems. X-axis: 1 x 20 mm Y-axis: 1 x 20 mm 1 x 8 mm Z-axis: 1 x 20 mm 1 x 8 mm As a countermeasure, if the wrong combination is made, an error should be displayed at the initial homing point and any operation in jog mode for each axis should not be accepted. This problem occurs when replacing new models and linear modules. Snapmaker should include the correct axis configuration in the product package and interlock it in the machine controller firmware. It should be recognized that this is a serious matter by Snapmaker for safety and machine integrity.

It was reported that this problem has been fixed in the latest Snapmaker2_V1.14.1 firmware.

Dec 13 2021: Snapmaker2_V1.14.1

Topic		Replies	Views
Help installing my Rotary Module Snapmaker 2.0	5	635	December 8, 2021
3d printing problems I have Snapmaker 2.0	88	1961	August 31, 2023
Linear Module Failure Snapmaker 2.0	18	1121	February 9, 2021
New 3D Printing Module Snapmaker 2.0	9	1149	February 4, 2022
3D Print Module Rebuild?	9	2668	June 2, 2023

Power Module / 3D Printer Module /Linear Module

Related topics