Dear all, this is my first print with Snapmaker A350T. It is the first layer of
the original example in Luban.
What went wrong? Any ideas? I printed with the original settings.
Many thanks
Holger
Many thanks
Holger
Reduce the z Offset. Recalibrate, maybe also recalibrate the probe sensor (See 6.4 herehttps://support.snapmaker.com/hc/en-us/articles/1500000672601-What-should-I-do-if-the-3D-Printing-Module-pushes-into-the-Print-Sheet-) and after one recalibrate.
Try to Set z Offset manually lower when still printing in the air.