Newbie 2ne 3D print: bed does not heat up after new FW

[xchrisd]

I don’t know if replaceable or not, here is some more information and the potential thermistor type:

Heated Bed Issue - Seeking Thermistor info from somewhere cold (climate or freezer)

Funnily enough I had planned to use a hair dryer for ten minutes (left pointing under the bed), but had a friend round so wasn’t in the cold garage very long. Today decided instead on a hot water bottle. After looking at digikey.com for a replacement thermistor with a suitable value resistance at standard room temperature (~110 KOhm) I found that a standard 100.8K@25c NTC Thermistor from TDK has a resistance of ~310k at 0celcius which is what I was experiencing, and causing an error in recognit…