Any suggestions? I can see a very small dot of light on the surface of the wood I’m using to calibrate the work surface for the first time ever using the laser. I see the light, barely, and I have it centered but it won’t leave engraving lines to check for the calibration

Laser pin point can be seen, but no marks

ElloryJaye February 20, 2021, 6:03pm 2

Topic		Replies	Views
Laser Not Burning, Calibration Fails Snapmaker 2.0 (3-in-1)	5	2283	February 23, 2021
Camera calibration, laser too weak or too far away Snapmaker 2.0 (3-in-1)	34	6083	November 13, 2021
SM2 Laser calibration failed (nothing engraved) Snapmaker 2.0 (3-in-1)	10	1668	August 17, 2020
Laser Autofocus Failure - No Laser Beam Snapmaker 2.0 (3-in-1)	18	4554	October 3, 2020
10 Watt Laser will not burn squre in paper Snapmaker 2.0 (3-in-1) Laser	7	495	December 25, 2023