Hello!,
First post here and new to the J1s- so far so good. My end goal is to print TPU and PVA with 0.6 nozzle:).
Question about the extruders- they have these orange button sliders on the side. What is that for?
Thanks!
Rolando
Hello!,
First post here and new to the J1s- so far so good. My end goal is to print TPU and PVA with 0.6 nozzle:).
Question about the extruders- they have these orange button sliders on the side. What is that for?
Thanks!
Rolando
The orange slider buttons are used to insert the filament manually into the hot-end. Using them is the recommended way for loading filament.