I’ve tried various Luban settings for Wall Thickness, but nothing seems to help. I get gaps between my walls. Between the wall lines themselves and the wall and top surface. I tried 0.8mm (2) to 1.6mm (4) walls, but printing more walls doesn’t help. I just want thicker wall lines not more walls. …

Thank you all. I ran the e-step calibration. It was definitely off. Previous value 212.21, new value 234.49 (only extruding 90.5mm of 100mm test). Wall gap is lot better now, but still not perfect. I’m currently doing a print using Cura with skin overlap setting. I will post pics shortly.

Gaps in wall lines

Snapmaker 2.0

xchrisd June 22, 2021, 5:15pm 10

Additionally calibrate linear advance to close the gaps between outline and infill.
The K factor of the community vary between 0.09 and 0.11, personally I use 0.1.

Maybe have a look at this:

Topic		Replies	Views
Ultimaker Cura PLA/ABS profile Snapmaker 2.0	5	855	May 8, 2022
Inconsistent wall thickness Snapmaker 2.0	13	1921	May 3, 2023
Walls beading a little bit Snapmaker 2.0	4	360	December 7, 2021
Surface artifacts in walls... problems continue after E & K adjustment Snapmaker 2.0	5	468	November 11, 2021
Holes on the top surface Snapmaker 2.0	2	837	December 13, 2020

Gaps in wall lines

Related topics