I made my first CNC file with fusion 360, and it seemed to load OK, but after setting the work origin, then backing Z up out of the way to ensure it didn’t hit a clamp, I ran “run boundary”. This caused the app to crash, screen says “Fab screen has stopped” “Open app again”. Upon reopening the syste…

Haven’t seen that problem. Only thing I can think of is that your dimensions are outside what your SM can handle and it’s choking on that. Have you tried using ncviewer.com to check the gcode? If you can share the gcode we can take a look. -S

Fusion 360 cnc file corruption

Snapmaker 2.0 (3-in-1)

ElloryJaye September 24, 2021, 6:26pm 3

There was a similar bug a while back that was supposedly fixed, but maybe not quite thoroughly enough?

https://forum.snapmaker.com/t/fabscreen-has-stopped-error-after-attempting-to-run-boundary-in-cnc-mode/13440

Topic		Replies	Views
Fabscreen has stopped error after attempting to run boundary in CNC mode Snapmaker 2.0 (3-in-1)	8	959	January 6, 2021
CNC problems with files from Fusion 360 Snapmaker 2.0 (3-in-1)	4	1021	December 19, 2020
CNC toolhead moving to wrong location? Snapmaker 2.0 (3-in-1)	4	574	May 17, 2021
SM A350 200W CNC goes nuts .... what is going on Snapmaker 2.0 (3-in-1)	5	370	July 10, 2024
CNC bit not rotating when using fusion 360 file Original (3-in-1)	4	682	January 8, 2023

Fusion 360 cnc file corruption

Related topics