Just ran through first time dual nozzle setup procedure. I like the auto Z leveling! However, I found a bug(?) - maybe/most likely it is only the GCode of the test model you print during calibration… However, you can see how the nozzle ending its job (before handing over to the other nozzle) goes to first 185°C, and then down to 150°C “standby” temperature. When a nozzle is prepared for printing after standby, it is first set to 185°C, then to 200°C. However, after the 185°C to 200°C change, the model GCode does not wait for the nozzle to reach target temp…
Small thing, but of course influences the print.