This thread is for dicussion of the Snapmaker 2.0 Firmware Updates.

[image] ml1140: I suggest you look into oktoprint… hast a small raspberry pi, Setup takes an hour and you can steer the machine and send prints from your laptop. With a small technical adaptation you can even power up the machine with it. I did not do this but rather added a WiFi power plug. Tha…

Showing the same information. I don’t know if the update worked the first time but ther was no error message. After going back to 1.09 and again to 1.10.1 I only made 1 print and it was successfull. Had no time. But I will monitor in the next days.

The problem may because you did not update the firmware successfully. Please let me know if the issue remains. Best regards

After upgrading to firmware v1.10 I’ve got three new things happening that I do not see specifically noted anywhere else when I search (Possibly missing it of course). I’m still an amateur at this, but I’ve got a series of successful prints so far, and haven’t had any issue until this latest release…

So my touchscreen is v 1.7 and the rest is blank on the touch screen. I have 1.10.1 on a USB but machine does not see / read the USB stick? I can not find Settings-> Firmware update to try via WiFi… was this possible with v 1.7? So… how to update firmware? Help? The USB stick is in DOS forma…

Hello, just starts to use my new snapmaker 2.0 A350 after installing the new firmware 1.10.1, I see there is still the “go to work origin” problem with the CNC where it starts by going to the Z0 and then X0 and Y0. It is very bad I calibrated the work origin form my first use, moved a bit the axe…

I’ve just added an emergency stop to my cabinet for this reason. I usually remember to move X & Y using jog before starting a job, its easy to forget though. I agree, this is a fundamental problem and should be fixed ASAP.

thanks for the tip about the “emergency stop” broke my mill end too by hitting stop on the computer, a couple of seconds later it stopped :frowning: now i know better have a problem with the enclosure (the machine touchpad doesn’t recognise it - but says the door is open) finally found the problem…

Discussion of Snapmaker 2.0 Firmware Updates

Snapmaker 2.0 (3-in-1)

rojaljelly September 15, 2020, 3:28pm 257

Format the Stick as FAT32.
FAT16 (DOS) is not working (at least for my sticks)

My Machine will not update

Topic		Replies	Views
Discussion of Snapmaker J1/J1s Firmware Updates J1/J1s IDEX Firmware	204	8426	April 27, 2026
A350 Issues and Suggestions Snapmaker 2.0 (3-in-1)	24	8441	August 30, 2022
Firmware request J1/J1s IDEX	28	1973	May 5, 2023
Random HELP - Ask here! Snapmaker2.0 Troubleshooting guides	165	8589	January 12, 2021
Snapmaker 2.0 improvements Snapmaker2.0 Troubleshooting guides Feature-Request , Bug-report	34	3406	June 16, 2024

Discussion of Snapmaker 2.0 Firmware Updates

Related topics