Day 2 - Not Great, Adhesion & Separation

[xchrisd]

Hey, you calibrated your bed too loose, now you have to recalibrate or set the z offset very small, i guess - 0,3mm.
Your layer lines are not connecting together, this has to be a full connected layer.

Btw you could discuss in your first thread because its a similar problem

Overwhelmed Newbie

I recommend xchrisd’s 3D Print Guide. It starts out fairly non-technical, but dives in pretty deep. Feel free to skip over sections you’re not comfortable with now, and come back later when you’re more experienced. First layer adhesion can be a couple of different things. You appear to be underextruding a bit (the first layer should be a continuous sheet of plastic, with minimal ridges. Your first layer appears to be a bunch of strings laid side by side, so I’d like to see wider strings tha…