Change the nozzle?

[brent113]

@Mebyon

I suspect we’re going to have to wait until one of these rails fails and then someone will take the dead one to pieces

That’s already happened about 50 times on here already. Best pictures are here

Excessive play in x-axis linear module bracket

Finally got a chance to pull it apart. (I swapped one of the Y’s with the X to get by). Arnold’s video was helpful, but incomplete and also a couple things wrong. I didn’t have time to make a video but I took a couple pictures. Here’s the procedure (note that this is how I did it and not official. Since all I got from support was “Need to adjust the sliders” and “it’s difficult” I’m considering that as sufficient instructions that I can proceed without voiding my warranty. Proceed at your ow…

Support posted a full assembly video here:

How to install the stainless steel strip of Linear Module?