I see all around on videos and posts about people increasing the amount of autoleveling calibration points. My A350 only have a 3x3 grid and I cannot for the life of me find out how to change it to be higher like 5x5.
Any help would be greatly appreciated.
1 Like
5x5 was added in a later firmware. There seem to be stability problems with the latest so go to 1.9 or 1.010.0
1 Like
I am on the latest firmware and still only have a 3x3 on my A350.
There is no setting that I have to set right?
Go into the touchscreen -> settings -> 3d printing, there should be a calibration grid setting somewhere. Going from memory, might be slightly different.
2 Likes
Go to Settings/3D Printing (under advanced settings heading) click on calibration grid then change to 4x4 or 5x5
1 Like