Help with relevelling the bed


I apologize if this has been covered before, I searched the forum but couldn’t find what I was looking for, so I thought I would ask. Recently I had my A350 dialed in beautifully and all my prints we coming out well. I hadn’t really used the laser or the CNC because of the hassle of changing over the beds and modules - so when the quick change kit came out I jumped at the chance to try these other options.

I got the kit and installed as per instructions and tried to get back to 3D printing first. What a nightmare! I have done several auto calibrations, and manual calibrations and I don’t know why but nothing is working as it was. I did take a dump of my settings before I installed the quick swap kit and it spat them out at the Binlinear Leveling grid data but I dont seem to be able to find a way to enter those values back into the system. Does anyone know how to put this info back into the device through Gcodes?

others < 0 1 2 3 4 5
others < 0 +43.394 +43.136 +42.903 +42.681 +42.403 +42.182
others < 1 +43.718 +43.478 +43.222 +43.011 +42.771 +42.559
others < 2 +43.941 +43.624 +43.344 +43.179 +42.958 +42.779
others < 3 +43.961 +43.704 +43.403 +43.311 +43.064 +42.861
others < 4 +43.684 +43.624 +43.414 +43.303 +43.083 +42.874
others < 5 +43.406 +43.310 +43.304 +43.182 +43.057 +42.950

Any assistance would be greatly appreciated.



there is a way, the reference is here

But I don’t think it will help you much.
run your current leveling data through bed leveling visualization. you might spot the issue.
Assuming you are on the latest firmware.