Cabinet wiring pin assignments

[xchrisd]

Hope this helps you, the middle pin should be the hall signal:

Warning: Security issue - Enclosure door detection not checked at start/not fail safe

Just wanted to start a new thread when I found this one. Still, since I took some pictures, I guess my post is worth something after all Took the freedom to make the title a bit more dramatic… TL;DR; When the machine starts up, it assumes door state “closed” regardless of the actual door state. Only after closing the door properly once, the door state by e.g. M1010 reflects the physical door state. This is a security problem when because of e.g. misaligned magnets (like after t…