Cabinet wiring pin assignments

[jknowles]

Hi

I bought one of the enclosures (not for a printer but for a laser based microscope system).

I was hoping that rather than having to fit new door sensors I could makes use of thrones already in the enclosure.

Does anybody know the wiring for these? I know the sensors are Hall effect and connect to box at the back but was hoping someone would know the pin/wire assignments

Thanks in advance!

[xchrisd]

Hope this helps you, the middle pin should be the hall signal:

Warning: Security issue - Enclosure door detection not checked at start/not fail safe

Just wanted to start a new thread when I found this one. Still, since I took some pictures, I guess my post is worth something after all Took the freedom to make the title a bit more dramatic… TL;DR; When the machine starts up, it assumes door state “closed” regardless of the actual door state. Only after closing the door properly once, the door state by e.g. M1010 reflects the physical door state. This is a security problem when because of e.g. misaligned magnets (like after t…

[jknowles]

Thanks. Worst case I could rewire the sensors, but I was hoping to find out the pin connections (or on the output lead) in the panel where all the sensors and LED’s etc connect to and hopefully interface with that.

Thanks again.