So I am new to 3d Printing and trying to figure out what my problem is here. I printed a few things without much issue, but the last two things that I have printed have been nothing but issues. the prints stick heavily to the bed, so much so that they end up leaving bits and pieces behind. I have tr…

The Snapmaker filament could very easily be the problem (the black packed in with the printers has an especially bad reputation, and Snapmaker has admitted that they got a bad batch from a third-party supplier). General consensus around here is to switch to any other brand you can find if you start…

hatchbox is a reasonable starter filament, frankly Matterhackers is super high quality and even cheaper but takes a little longer to get.

Your head is too low to the bed. [image]

i have a verrry hard time getting “good”, im usually halfway between good and too high hehe. all the time takin my skirts off one line at a time :frowning: i just cant bring myself to smoosh it any further because it always gets all ganky. so my settings are all wonky to help compensate :joy:

UPDATE: I have spent the weekend printing and have found a few issues that I was battling. The filament that I was using was just plain garbage. I bought some spools from snapmaker and the white filament I had been using was just terrible from the start. In retrospect I should have known this. I …

Bed Adhesion Issue

Snapmaker 2.0 (3-in-1)

xchrisd February 6, 2021, 7:24pm 4

Your head is too low to the bed.

Can't Eliminate Stringing

Topic		Replies	Views
Prints not sticking to bed Snapmaker 2.0 (3-in-1)	6	1674	May 1, 2022
Bed adhesion is way too high Snapmaker 2.0 (3-in-1)	11	1705	June 26, 2021
Please help me...with this 3d print malfunction Snapmaker 2.0 (3-in-1)	39	770	July 31, 2024
Issues printing, getting filament to stick to bed Snapmaker 2.0 (3-in-1)	8	1099	January 5, 2022
Inconsistent adhesion Snapmaker 2.0 (3-in-1)	6	992	November 29, 2020

Bed Adhesion Issue

Related topics