My Vader print is missing some layers not Shure why ? Thanks [PXL_20240204_191921317.MP]

RESOLVED : thanks everyone for all the help. I found 2 issues ,1minor 1 major. Filament spool binding was a slight problem on occasion. Major intermittent problem was a loose cable.

Need MANY more details. What machine? What filament brand & type? What slicer settings? What calibrations have been done?

Snapmaker 2.0/350 Inland red PLA 190-210c Slicer ? looking into that definition, sorry All calibration on the home screen completed in order. Thanks a ton.

Hi THXRWP, Not sure how long you’ve had your A350, I’ve had mine for a year now, also using Luban. I have seen this sort of behaviour, but the reasons might not be the same. After about 5kg of mixing PLA with PETG in the same hot end the 0.4mm nozzle developed a clog. Perhaps I was running it too ho…

Ya, curious to see the slicer settings as well. I’m guessing a very large layer height.

layer height: .16 speed: 50mm/s model structure :medium support : none adhesion type: skirt Note: my 1st print (this was my 2nd) was a cube that turned out nice.

Well those parameters seem reasonable… this is somewhat daft but, try the cube again and see how it turns out, then try Jeff Vader again (you have to be an Eddie Izzard fan). I notice your settings have no support and a fairly high print speed, that might cause unusual behaviour for a model with the…

thanks man, was printing the cube already right now and had to stop it ,looks like its just pouring out red, getting piled up all over the nozzle and then the project. Could red be bad ? white was fine, or did i screw up my first unload/load seemed pretty easy ???

UR welcome, it’s possible the heat required for red PLA is lower, or the extrusion settings are corrupt/incorrect in Luban. I notice each material has a separate profile for colour too… Was the white filament also PLA or PETG. That runs quite a bit hotter and PLA would not respond well at that tempe…

Hey, it seems like you are new to 3D printing and the Snapmaker, can I recommend, when and where you have time, you have a read of this forum post: 3d Print Guide_Walk Through - Snapmaker 2.0 / Getting Started - Snapmaker: where creation happens . There are a lot of useful guides on there including …

Air Gap/ missing layers when printing?

Snapmaker 2.0 (3-in-1)

THXRWP February 19, 2024, 12:24am 13

BINGO ! thanks

Topic		Replies	Views
Gaps in certain spots Snapmaker 2.0 (3-in-1)	19	2220	March 30, 2021
Please help me...with this 3d print malfunction Snapmaker 2.0 (3-in-1)	39	657	July 31, 2024
Please help, I don’t understand what setting I need to adjust Snapmaker Luban	71	1855	March 25, 2023
Lines and gaps between print layers Original (3-in-1)	8	2712	August 23, 2020
3D Printer Under extrudes or not at all Snapmaker 2.0 (3-in-1)	32	5771	August 27, 2020

Air Gap/ missing layers when printing?

Related topics