Hallo Team. I have been testing out the 2.0 3d printing module for few weeks now and everything looks good so far. Due to small space of my workshop, i notices small amount of PLA smell which was a bit annoying. I installed the snapmaker enclosure without the flex pipe due to space and no air exi…

SM is working on releasing a filter. There is also one here on the forums that someone designed. Sorry I don’t remember witch thread.

To be explicit, the original post was asking about an exhaust filter. [image] fatikh: The question is :0 is there any sort of filter which can be installed on the enclosure? or is there any recommended type? There’s no pre-built one, so you’ll have to roll your own out of parts. If your pri…

Yes that’s exactly what I did today, I searched for an activated carbon filter and started putting a filter box from parts laying around. Will check the performance :nerd_face: Once the SM team finish the filter will defiantly check it out

Yes that was the link here is the post with the filter design: [image] Flat exhaust for enclosure You should see how the filter just ‘slides’ onto the duct at the fan, so to get airflow you’ll have to notch out about 1/4 of the cylindrical wall, in whatever orientation you choose. filter_frame.…

Air filter for the 2.0 enclosure

Snapmaker 2.0 (3-in-1)

brvdboss November 25, 2020, 1:51pm 3

Is this the one you are referring to? : Flat exhaust for enclosure

Topic		Replies	Views
Filtration Kit for Enclosure Snapmaker2.0 Troubleshooting guides	2	1519	September 21, 2018
Filter / exhaust inside enclosure Snapmaker 2.0 (3-in-1)	1	324	June 14, 2023
Dealing with fumes Snapmaker 2.0 (3-in-1)	9	2945	April 3, 2021
Enclosure fume venting Snapmaker 2.0 (3-in-1)	4	1673	August 29, 2020
Can I use the Filter sideways with a custom enclosure? Snapmaker 2.0 (3-in-1) Accessories	3	410	August 15, 2023

Air filter for the 2.0 enclosure

Related topics