Z-axis testing?

[xchrisd]

It’s more likely a warping model than a defective z-axis.

Too hot temperature because of too low layer times or not enough cooling could easily cause this.

Z-hop could prevent this.

Here is a topic for better understanding:

Snapmaker Tower Tips! (Images included)

Hey all! If you’ve tried to make a small tower with the snapmaker, you;ve probably noticed the walls look terrible and it isn’t setting properly. [Album] Imgur [Imgur] Figure 1: It’s difficult to see, however, the print has unevent sides and caved in sections. What causes this? This is caused by the nozzle never having time to …